How to fix the heater if it breaks? Popular topics and practical solutions on the Internet in the past 10 days
With the recent cold wave, heating failures have become a hot topic on the Internet. According to big data statistics, in the past 10 days, the search volume related to "heating repair" has increased by 320% month-on-month, especially in the northern region where the problem has been concentrated. This article will combine the latest hot topics to provide you with structured solutions.
1. Popularity analysis of the entire network (last 10 days)
| hot topics | amount of discussion | main focus |
|---|---|---|
| Collective heating is not hot | 187,000 items | Blocked pipes/insufficient pressure |
| Wall mounted boiler fault code | 93,000 items | E1/E9 error handling |
| Floor heating does not heat up | 68,000 items | Divider adjustment/pipe cleaning |
| The radiator is partially cold | 52,000 items | How to eliminate air blockage |
| Repair cost dispute | 39,000 items | Charging standards/complaint channels |
2. Common fault diagnosis table
| Fault phenomenon | Possible reasons | Self-test method |
|---|---|---|
| The whole house is not hot | Main valve closed/pipe blocked | Check the entrance valve/touch the pipe temperature difference |
| Not hot in part | Air blockage/hydraulic imbalance | Exhaust valve to deflate/adjust water divider |
| Abnormal noise and water leakage | Loose interface/aging of gaskets | Listening positioning/toilet paper test |
| Large temperature fluctuations | Thermostat failure/insufficient water pressure | Reset thermostat/watch pressure gauge |
3. Step-by-step maintenance guide
Step 1: Basic investigation
① Check whether the heating main valve is fully open (open when the handle is parallel to the pipe)
② Observe the pressure gauge (1.5-2Bar is normal)
③ Touch the temperature difference of the pipes (the inlet pipe should be obviously hotter than the return pipe)
Step 2: Exhaust Treatment
① Use a flat screwdriver to turn the exhaust valve counterclockwise
② Until continuous water flow is discharged (about 30-60 seconds)
③ Pay attention to using a container to collect water to prevent the floor from soaking
Step 3: Clean the filter
① Close the water inlet valve (important!)
② Use an adjustable wrench to remove the Y-type filter
③ Clean the filter with a wire brush and reinstall it as it is.
4. Maintenance cost reference
| Services | average market price | Warranty period |
|---|---|---|
| Door-to-door testing fee | 50-100 yuan | None |
| Pipe cleaning | 300-800 yuan | 1 year |
| water pump replacement | 400-1200 yuan | 2 years |
| Thermostat repair | 150-400 yuan | 6 months |
5. Emergency handling
Please stop using it immediately and contact professional maintenance when the following conditions occur:
① The pipe bursts and sprays water
② Smell gas odor (wall-hung boiler users)
③ Circuit sparking phenomenon
6. Preventive maintenance suggestions
① Carry out system pressure test before heating season
② Have pipes professionally cleaned every 2 years
③ When not in use for a long time, it should be filled with water for maintenance.
Note: According to the latest consumer complaint data, when choosing a maintenance company, please confirm that it has the "Qualification Certificate for Heating Equipment Installation and Maintenance" to effectively avoid disputes.
check the details
check the details
en
